AETHRA STARMODEM USB DRIVER

Power is supplied by usb cable ;. USB connection not available. Physical and electrical specifications. GSM activity a phone call, internet traffic. Its digital inputs are only compatible with volt free outputs clean contacts. This port provides a fast 8-bit bus, where it is possible to connect more slave peripherals. AbilisUB Supported from 7.

Uploader: Kek
Date Added: 14 April 2009
File Size: 48.32 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 14354
Price: Free* [*Free Regsitration Required]

Each output is available both as normally closed and normally open. Only the central pins 4,5 and 3,6 are switched! USB connection not available. The digital outputs can drive any kind of device, accordingly with the electrical specifications. This device allows to exchange data and sms udb an UMTS key. Front Panel and connector aetrha. The digital inputs are general purpose, so they can be used to connect any kind of hardware additional ring buttons, digital sensors, etc.

Aethra, SpA. Drivers Download

This device checks the keepalive, so if the master Mx doesn’t reply to the keepalive signal, the link is assumed to be down and the line is switched to the backup device Starrmodem until the link is up again. Each input will cause to dial a different number. Simbox – Block scheme. This port provides a fast 8-bit bus, where it is possible to connect more slave peripherals.

Recent Drivers  DI1610 TWAIN DRIVER

Up to 6 modems can be installed into the same Abilis. Pins 1,2 and 7,8 are not connected. SIM nn card used by the Stxrmodem. Citobox – Block scheme. Abilis is not driving the device. The digital outputs are relay-based and have 3 volt free contacts i.

Each board allows to plug up to 16 sim cards. It can be used as backup line when the main one fails, or to establish a connection toward Internet when calling an ISDN number data call back. us

aethra adsl usb starmodem um | dgpr network

Jumpers configuration only for PCB Ver. AbilisUB Supported from 7. The speaker and the microphone are decoupled by a transformer.

The volume of the microphone and the speaker can be manually regulated with the corresponding trimmers, all of which are externally accessible on the front. Power is supplied by usb cable.

Its digital inputs are only compatible with volt free outputs clean contacts. It can be configured as clean contact input default or optoisolated input use voltages in the range 5V – 12V. When no module is present, the analog inputs are not usable.

Recent Drivers  HP 7580 PRINTER DRIVER

Jumpers configuration is available only in PCB Ver. Warning Output relays support: Auxiliary pin, leave disconnected if unused connect to MIC in a special BTicino connection scheme, in dtarmodem to provide power to the Microphone line.

The CITO part offers two completely separated interfaces for doorphones. This means that the bandwidth is permanently robbed to other devices connected to the same controller.

Each input can be manually configured through its corresponding couple of jumpers. The status of the relays RA and RB follows the one of the communication.

If the sim is remote this doesn’t happen; a module resets itself every time a remote sim is connected.